Date posted:
MCI was asked by a new customer, that services the oil and gas sector, nuclear power and national fabricators, to replace the control system for a shot blast process. The customer asked not only for us to replace the old panel, but also to redesign it. We were asked to…
Date posted:
MCI received a touch screen control panel from one of our regular customers. The touch screen had been damaged by someone using a ballpoint pen on it. MCI’s engineers replaced the damaged parts and tested it before returning it to the customer. One happy customer and the machine was back…
Date posted:
MCI received an ECU for a well known German vehicle. Once our engineers had cleaned the circuitboard up, we were able to diagnose and replace a faulty inductor coil. Another happy customer. If you are having electrical or electronic problems with your vehicles, give MCI a call on 01324 611371…
Date posted:
MCI was called out to look at a customer’s pastry making machine. Production had halted – no sausage rolls or steak bakes. Our engineer found the cause of the error and quickly went to work and repaired the machine in good time. The pastry machine was back producing savoury pastries…
Date posted:
MCI received this machine control panel from a food manufacturer. Our engineers saw that faulty relays and bases were preventing the machine from running properly. The job was urgent due to production demand, so we turned the repair around in less than a week for the customer. As you can…
Date posted:
MCI received a machine drive from a hot melt glueing system for MDF boards. As you can see, the board was badly damaged. After a good clean up and replacement of damaged parts, the board is back to its old self. If you are having problems with your machine circuitry,…
Date posted:
MCI received a railway controller from a customer. A chip in the board had clearly blown and the integrated circuit was in need of repair. We believe that an external overload probably caused the fault. MCI replaced the chip and the controller was fixed. If you are having problems with…
Date posted:
MCI received a CNC display from a customer who manufactures hydraulic rams. The display was a digital read-out for a CNC centre lathe. It had failed due to the age of some of its internal components. MCI replaced the worn components and the power supply to get it working again.…
Date posted:
MCI received a call from a new client that was having problems with their production line that had an electrical fault. After doing some fault finding, our engineer saw that water ingress had caused a motor soft start to fail. Further investigation also revealed a damaged contactor. We sourced a…
Date posted:
MCI got a servo motor in for repair. As you can see from the photos, it didn’t take much time to notice that some of the components had burnt out. Luckily, we had replacements in our workshop. The damaged components were quickly swapped. If you are having problems with your…